4/12/2021 0 Comments Board And Batten How To
Use your outlet plate to help get an even reveal around all sides.Using plans or information found on SawdustGirl.com indicates that you agree with the Terms of Use policy and will accept full responsibility for the process and outcome of any project you attempt.Plans and information published on SawdustGirl.com may not be reproduced, republished or distributed in any manner without written permission from Sandra Powell, Sawdust Girl.Actual projects built using Sawdust Girl plans may be published on your own site without instructions or tutorial as long as you provide a link to my original post with full post title or SawdustGirl.com as link title.
I decide one each side more wouldnt be enough, 3 would not leave enough gap in between, so 2 was just right. But, I didnt. So I will have to make do with what I have Which is nothing really other than finished photos. Board And Batten How To Do TheThat said, I have had so so so many messages and comments asking me how to do the board and batten panelling in my spare room, that I couldnt resist jotting it all down retrospectively and popping a tutorial up on the blog. So I was full of confidence and wanting to do it again in the spare room. ![]() Browse Pinterest and youll see just how many different ways you can panel a wall. I already had a Pinterest board on the go from when I was gathering inspiration for the office, so I started adding to it for the bedroom, and decided after seeing lots of images, that the board and batten style was the one for me. Modern, clean looking and easy to do (no angles other than right angles), I was confident I could do it myself. What became apparent is that nearly everything I came across in my research suggested it was easy to doyay Here is a simple step by step tutorial for how I created and installed our simple and effective board and batten wall panelling. So please excuse that this post is wordy it just goes into a lot of details that lots breeze over.). Grab yourself several pieces of paper, a pencil, tape measure, a bucket load of patience and prepare to get stuck in with some numbers. Measure across the very bottom, just above your skirting board, and measure further up the wall approximately where you would like your top panel to be. You can make your panelling any height you want, but I just decided to get approximately 23 of the way up. For this example, Im going to say that my wall was 200cm wide. As I mentioned above, I knew I wanted them approx 23 up the wall. All I did here was work out by eye were it would look good for the panelling to stop, measured that height and rounded that measurement to the nearest 10 to make it easier (remembering 160cm for example is easier than 162.5cm, and you wont be able to tell the difference with that 2.5cm). For this example, lets say the total height of my panelling was going to be 160cm. I measured from on top of the skirting boards rather than the floor. I did guess work here and working by eye which is how I work best. I picked 10cm as a starting point for the width of my panels, as Im all about the round numbers. I checked this on my tape measure to see the size, and it looked like a good width to me. Not too thick, not too skinny that it wouldnt make an impact. Which means all of my vertical panels needed to be 140cm tall. This part makes up the main look of the panelling so you have to get it right. I knew I wanted one dead centre in the middle, and I wanted one against each edge to perfectly frame the panelling. That meant that with those three in place, I could see the space left either side of the centre panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |